Stafford, Texas
Auto Repair, ECU Programming & ADAS Calibration in Stafford, TX
Priority partner turnaround for body shops off US-90A.
General Auto Repair for Stafford Drivers
Everyday mechanical work handled with dealer-level tooling and plain-English explanations, then verified before your vehicle leaves the bay.
- Brake Service & ABS — Pads, rotors, calipers, brake fluid exchange, ABS module diagnostics and bleed procedures.
- A/C & Heating — Houston-summer-ready evacuate and recharge, compressor replacement, blend door and HVAC actuator repair.
- Suspension & Shocks — Struts, control arms, bushings and ride-height correction — followed by required camera recalibration.
- Engine Diagnostics — Check-engine light, misfires, drivability faults and no-start conditions traced with OEM scan tools.
- Electrical Repair & Diagnostics — Parasitic drains, starter and alternator failures, module communication faults and wiring issues traced with factory wiring diagrams.
- Maintenance & Tune-Ups — Oil services, filters, plugs, coils, fluids and factory-interval inspections with digital reporting.
ADAS Calibration & Partner Work in Stafford
Body shops, dealerships, glass companies and auctions in Stafford use our bay as their calibration department — with documentation on every job.
- Windshield Camera Calibration — Static and dynamic forward-facing camera calibration after glass replacement, per OEM target specs.
- Radar Sensor Calibration — Adaptive cruise and collision-avoidance radar aiming after bumper, grille or frame work.
- Blind Spot Alignment — Rear corner radar module aiming and validation for lane-change assist systems.
- 360° Camera Setup — Surround-view mat calibration, stitching correction and park-assist verification.
- ECU Programming & Module Flashing — OEM software updates, module replacement coding, key and immobilizer programming.
- Pre & Post Collision Scanning — Documented pre-repair and post-repair scan reports built for insurer approval.
Core Services
What Stafford Drivers & Shops Come to Tony's For
Jump straight to the service page that matches what your vehicle needs.
Auto Repair Services in Stafford
Brakes, A/C, suspension, engine diagnostics and routine maintenance for Stafford drivers.
ADAS Calibration in Stafford, TX
Static and dynamic calibration for windshields, bumpers, sensors and camera systems.
Electrical Repair & Diagnostics in Stafford
Parasitic drains, wiring faults, module communication and sensor diagnostics.
B2B Partner Services Near Stafford
Same-day calibration and diagnostic partner work for body shops, dealerships and auctions.
FAQ
Stafford ADAS & Auto Repair Questions
Common questions from Stafford, TX drivers and shops.
Do you offer ADAS calibration for Stafford, TX vehicles?
Yes. We perform static and dynamic ADAS calibration for Stafford drivers, body shops, glass companies and dealerships at our South Houston bay, using OEM procedures and scan tools. Every job leaves with a printed pre- and post-scan report.
How long does a diagnostic or calibration take for a Stafford customer?
Most diagnostic scans take 1–3 hours and most calibrations are completed the same day. Partner work dropped off from Stafford is typically targeted for same-day or next-day return.
How far is your shop from Stafford?
We are located at 301 State St, South Houston, TX 77587, just off the Gulf Freeway, which keeps us an easy drive from Stafford and the rest of Greater Houston.
Do you handle electrical repair and ECU programming for Stafford vehicles?
Yes. We trace parasitic drains, wiring faults, module communication issues and sensor failures, and we perform OEM ECU programming and module coding matched to your VIN.
Nearby